Final Cut Pro Logic Effects
- Welcome
-
- Intro to echo effects
-
- Intro to Delay Designer
- Delay Designer interface
- Main display controls
- View buttons
- Navigate the Tap display
- Create taps
- Select taps
- Move and delete taps
- Use the tap toggle buttons
- Edit taps in the Tap display
- Align tap values
- Edit filter cutoff
- Edit pan
- Tap parameter bar
- Tap shortcut menu
- Reset tap values
- Master section controls
- Use Delay Designer in surround
- Modulation Delay
- Stereo Delay
- Tape Delay
- Copyright
Ringshifter Envelope Follower controls in Final Cut Pro for Mac
The Ringshifter oscillator Frequency and Dry/Wet parameters can be modulated with the internal envelope follower—and the LFO (see Ringshifter LFO modulation controls in Final Cut Pro for Mac). The oscillator frequency even allows modulation through the 0 Hz point, thus changing the oscillation direction.
The envelope follower analyzes the amplitude (volume) of the input signal and uses this to create a continuously changing control signal—a dynamic volume envelope of the input signal. This control signal can be used for modulation purposes.
To add the Ringshifter effect to a clip and show the effect’s controls, see Add Logic effects to clips in Final Cut Pro for Mac.
Power button: Turn the envelope follower on or off.
Sens (Sensitivity) slider and field: Determine how responsive the envelope follower is to the input signal. At lower settings, the envelope follower reacts only to the most dominant signal peaks. At higher settings, the envelope follower tracks the signal more closely, but may react less dynamically.
Attack slider and field: Set the response time of the envelope follower.
Decay slider and field: Control the time it takes the envelope follower to return from a higher to a lower value.
Download this guide: PDF