Modulate Sculpture LFOs in Logic Pro for Mac
Two modulation targets can be assigned per LFO. An optional via modulation can also be assigned.
The LFOs also feature a simple envelope generator, which is used to control the time it takes for the LFO modulation to fade in or fade out. At its center position, which is accessed by clicking the middle mark, the modulation intensity is static—in other words, no fade-in or fade-out occurs.
LFO target and source parameters
LFO 1/2 On/Off buttons: Turn each LFO on or off, independently.
Modulation Target pop-up menus: Choose the modulation targets.
Via source pop-up menus: Choose (or disable) the via sources that control the modulation scaling for each LFO.
Amt sliders: Move to set the modulation amount (when the incoming via signal is 0)— for example, when the modulation wheel is at its minimum position.
In cases where the via source is set to off, only one amount slider is visible (the via amount slider is hidden). In cases where any via source other than off is selected, there are two sliders.
Via amount sliders: Set the maximum via modulation amount, such as when the Modulation wheel is at the maximum position, for example.