Tape Delay in Logic Pro for Mac
Tape Delay simulates the sound of vintage tape echo machines. It can run at a free rate or can be synchronized with the project tempo. The effect is equipped with a highpass and lowpass filter in the feedback loop, making it easy to create authentic dub echo effects. Tape Delay also includes an LFO for delay time modulation. This can be used to produce chorus effects, even on long delays.
To add Tape Delay to your project, choose Delay > Tape Delay in a channel strip Audio Effect plug-in menu. See Add, remove, move, and copy plug-ins in Logic Pro for Mac.
Tape Delay parameters
Tempo Sync button: Synchronize delay repeats with the project tempo (including tempo changes). The current tempo is shown in the field below the button. Set note values with the Note pop-up menu or Delay Time knob.
Delay Time knob and field: Set the delay time in milliseconds. Notes (and dots) are displayed around the Delay Time knob when synchronized with the project tempo. Click these buttons or dots (or rotate the knob) to choose an exact synchronization value.
Note: Clicking note or dot values resets the Deviation parameter value. Choose a value from the Note pop-up menu to retain the current Deviation value.
: 2 and x 2 buttons: Halve or double the current delay time.
Note pop-up menu: Set the grid resolution for the delay time.
Deviation field: Set the amount of deviation from the grid.
Smoothing slider and field: Even out the LFO and flutter effect. See LFO and Flutter parameters.
Clip Threshold knob: Set the level of the distorted tape saturation signal. Higher values produce no additional audible distortion. Lower values result in an aggressive distortion. This behavior is influenced by high Feedback values which result in eventual distortion, irrespective of the Clip Threshold value. That said, aggressive distortion and signal breakup are achieved far more rapidly when a low Clip Threshold level is used.
Spread knob and field: Set the width of the effect signal in stereo instances. This parameter is not available in mono instances.
Tape Head Mode buttons: Choose Clean or Diffuse mode to emulate a different tape head position. This affects the behavior of other parameters, such as Flutter and Feedback.
Low/High Cut sliders and fields: Cut frequencies below the Low Cut value and above the High Cut value to shape the sound of taps (delay repeats) with the highpass and lowpass filters. The filters are located in the feedback circuit, which means that the filtering effect increases in intensity with each delay repeat. If you want an increasingly muddy and confused tone, move the High Cut slider toward the left. For ever thinner echoes, move the Low Cut slider toward the right. If you can’t hear the effect, check the Dry and Wet controls and the filter settings.
LFO Rate knob and field: Set the speed of the LFO.
LFO Intensity knob and field: Set the amount of LFO modulation. A value of 0 turns off delay modulation.
Flutter Rate/Intensity knobs and fields: Simulate the speed irregularities of tape transports used in analog tape delay units.
Flutter Rate: Set the speed variation.
Flutter Intensity: Set the intensity of the “flutter” effect.
Feedback knob: Set the amount of delayed and filtered signal that is routed back to the input. Set to the lowest possible value to generate a single echo. Set to 100% to endlessly repeat the signal. The levels of the original signal and taps (echo repeats) tend to accumulate and may cause distortion. Use the Character parameters to change the color of these overdriven signals.
Freeze button: Capture current delay repeats and sustain them until turned off.
Dry/Wet sliders and fields: Independently control the amount of original and effect signal.