MultiMeter Peak parameters in Logic Pro for Mac
MultiMeter offers common Peak parameters for the Analyzer and Goniometer metering tools. The Level and Correlation meters have discrete Peak parameters. See MultiMeter Level and Loudness.
MultiMeter Peak parameters
Peak pop-up menu: Choose the hold time for all metering tools. Choose 2, 4, or 6 seconds—or infinite.
Note: The (Peak) Hold button must be turned on for the selected time value to have an effect.
Hold button: Turn on peak hold for all metering modes in MultiMeter. This is displayed in the following ways:
Analyzer: A small segment above each 1/3-octave level bar indicates the most recent peak level.
Goniometer: All illuminated pixels are held during a peak hold.
Reset button: Reset the peak hold segments of all metering tools.
Return Rate pop-up menu: Shown only in mono instances. Choose how quickly analyzed signals return from peak/maximum levels to zero or incoming signal levels. This is expressed in dB per second.
Note: This parameter is shown below the MultiMeter Level and Loudness when a stereo instance is active.