Final Cut Pro X: Importing RED Media

You can import and work with REDCODE RAW (R3D) files in Final Cut Pro X 10.0.6 and later. In order for Final Cut Pro X to recognize the R3D RAW files, you must download and install software provided by RED.

Visit and download the "RED APPLE WORKFLOW INSTALLER V2".

If you also have a RED ROCKET™ card from RED, download the "RED ROCKET™ INSTALLER" to install the latest driver and firmware.

Additional Information

Important: Mention of third-party websites and products is for informational purposes only and constitutes neither an endorsement nor a recommendation. Apple assumes no responsibility with regard to the selection, performance or use of information or products found at third-party websites. Apple provides this only as a convenience to our users. Apple has not tested the information found on these sites and makes no representations regarding its accuracy or reliability. There are risks inherent in the use of any information or products found on the Internet, and Apple assumes no responsibility in this regard. Please understand that a third-party site is independent from Apple and that Apple has no control over the content on that website. Please contact the vendor for additional information.
Last Modified: Dec 19, 2013
Not helpful Somewhat helpful Helpful Very helpful Solved my problem
Print this page
  • Last Modified: Dec 19, 2013
  • Article: HT5341
  • Views:

  • Rating:
    • 61.0

    (383 Responses)
Start a Discussion
in Apple Support Communities
See all questions on this article See all questions I have asked