ChromaVerb Output EQ in MainStage
The details view contains advanced parameters and shows the built-in six-band Output equalizer.
The main view contains the main view controls and shows a Damping EQ overlay in the graphic display. Click the Main or Details buttons at the upper right to switch between views.
ChromaVerb Output EQ parameters
Output EQ on/off button: Turn on to enable the Output EQ, which adjusts frequencies of the overall combined reverb and source signal.
Main/Details button: Switch between the main view and the details view.
Graphic display: Shows the six-band Output EQ curve, which you can interact with directly in the display or the fields below it.
Band 1 On/Off button: Switch on a highpass filter that allows high frequencies to pass and reduces the level of low frequencies near the cutoff (set) frequency. When active, you can change band parameters directly in the graphic display.
Band 1 background or dot: Drag the red shaded area horizontally to change the frequency value. Drag the red dot horizontally to change the frequency and drag vertically to change the Q value. Option-click to reset to default values. Hold Option-Command, then drag vertically to change the Q value.
Band 2 On/Off button: Switch on a low shelving filter that adjusts the level of low frequencies and has a minimal impact on frequencies above the cutoff (set) frequency. When active, you can change band parameters directly in the graphic display.
Band 2 background or dot: Drag the orange shaded area or dot horizontally to change the frequency and drag vertically to change the gain value. Option-click to reset to default values. Hold Option-Command, then drag vertically to change the Q value.
Band 3 On/Off button: Switch on a low parametric filter with three controls. Frequency sets a center frequency. Q sets the width of the frequency band around the center frequency. Gain sets the level of the band. When active, you can change band parameters directly in the graphic display.
Band 3 background or dot: Drag the green shaded area or dot horizontally to change the frequency and drag vertically to change the gain value. Option-click to reset to default values. Hold Option-Command, then drag vertically to change the Q value.
Band 4 On/Off button: Switch on a high parametric filter with three controls. Frequency sets a center frequency. Q sets the width of the frequency band around the center frequency. Gain sets the level of the band. When active, you can change band parameters directly in the graphic display.
Band 4 background or dot: Drag the blue shaded area or dot horizontally to change the frequency and drag vertically to change the gain value. Option-click to reset to default values. Hold Option-Command, then drag vertically to change the Q value.
Band 5 On/Off button: Switch on a high shelving filter that adjusts the level of high frequencies and has a minimal impact on frequencies below the cutoff (set) frequency. When active, you can change band parameters directly in the graphic display.
Band 5 background or dot: Drag the purple shaded area or dot horizontally to change the frequency and drag vertically to change the gain value. Option-click to reset to default values. Hold Option-Command, then drag vertically to change the Q value.
Band 6 On/Off button: Switch on a lowpass filter that allows low frequencies to pass and reduces the level of high frequencies near the cutoff (set) frequency. When active, you can change band parameters directly in the graphic display.
Band 6 background or dot: Drag the pink shaded area to change the frequency value. Drag the pink dot horizontally to change the frequency and drag vertically to change the gain value. Option-click to reset to default values. Hold Option-Command, then drag vertically to change the Q value.
Frequency field: Set the frequency of the selected EQ band.
Gain field: Set the level of the selected EQ band (bands 2 to 5).
Order field: Set the order (filter slope) for band 1 or band 6.
Q field: Set the band width surrounding the frequency of the selected EQ band.