Ringshifter Output controls in Final Cut Pro for Mac
The Ringshifter effect’s Output controls set the balance between the effect and input signals as well as the width and feedback of Ringshifter.
To add the Ringshifter effect to a clip and show the effect’s controls, see Add Logic effects to clips in Final Cut Pro for Mac.
Dry/Wet knob and field: Set the mix ratio of the dry input signal and the wet effect signal.
Feedback knob and field: Set the amount of the signal that is routed back to the effect input. Feedback adds an edge to the Ringshifter sound and is useful for a variety of special effects. It produces a rich phasing sound when used in combination with a slow oscillator sweep. Comb filtering effects are created by using high Feedback settings with a short delay time (less than 10 ms). Use of longer delay times, in conjunction with high Feedback settings, creates continuously rising and falling frequency shift effects.
Stereo Width knob and field: Determine the breadth of the effect signal in the stereo field. Stereo Width affects only the effect signal of Ringshifter, not the dry input signal.
Env Follow (Envelope Follower) slider and field: Determine the amount of Dry/Wet parameter modulation by the input signal level.
LFO slider and field: Set the LFO modulation depth of the Dry/Wet parameter.
Download this guide: Apple Books | PDF