iPhone 18 Pro Top Speaker
Before You Begin
Warning
Read Battery Safety and follow workspace and battery handling guidelines before you begin.
Remove the following parts before you begin:
Tools
Adjustable torque driver (10–34 Ncm)
Crosshead 50 mm bit
ESD-safe tweezers
Nylon probe (black stick)
Refer to a full list of tools required for all repairs.
Removal
Note: If you've already completed the removal steps, skip to reassembly.
Use the 10–34 Ncm adjustable torque driver and crosshead bit to remove three crosshead screws from the top speaker.
Lift the top speaker out of the enclosure.
Caution: Don't damage the springs on the top speaker. If the springs are damaged, replace the top speaker.
Reassembly
Screw location diagram
Position the top speaker in the enclosure at an angle as shown. Then lower it into the enclosure.
- Caution: Ensure that the top speaker gasket is fully aligned with the indentation in the enclosure and no debris is present on the top of the housing.
Set the torque value on the 10–34 Ncm adjustable torque driver to 14.5 Ncm. Use the adjustable torque driver and crosshead bit to partially install three new crosshead screws (E1-E3) in the order listed below. Then fully install the screws in the same order.
923-15920 (E1)
923-15921 (E2)
923-15921 (E3)
Reinstall the following parts to complete reassembly: