Modifying this control will update this page automatically

Route audio via send effects in MainStage
You use send effects when you want to isolate effect plug-ins from a channel strip’s signal flow, or when you want to use the same effect on more than one channel strip. By creating a send, you split the channel strip’s signal. The channel strip’s main signal continues its route to the chosen output. The other part of the signal is routed down a parallel path, via a bus to an aux channel strip. You use the Send Level knob to control the amount of signal that is sent via the bus.
You use the Send pop-up menu to configure where in the channel strip’s signal the send occurs, and to set the destination for the send’s parallel routing.