Intro to Enveloper in Final Cut Pro for Mac
Enveloper is an unusual processor that lets you shape the attack and release phases of a signal—the signal’s transients, in other words. This makes it a unique tool that can be used to achieve results that differ from other dynamic processors.
The most important Enveloper controls are the two Gain sliders, one on each side of the central display. These govern the Attack and Release levels of each respective phase.
Boosting the attack phase can add snap to a drum sound, or it can amplify the initial pluck or pick sound of a stringed instrument. Attenuating the attack causes percussive signals to fade in more softly. You can also mute the attack, making it virtually inaudible. A creative use for this effect is alteration of the attack transients to mask poor timing of recorded instrument parts.
Boosting the release phase also accentuates any reverb applied to the affected clip. Conversely, attenuating the release phase makes audio originally drenched in reverb sound drier. This is particularly useful when working with drum loops, but it has many other applications as well. Let your imagination be your guide.
When using Enveloper, set the Threshold to the minimum value and leave it there. Only when you seriously raise the release phase, which boosts the noise level of the original recording, should you raise the Threshold slider a little. This limits Enveloper to affecting only the useful part of the signal.
Drastic boosting or cutting of either the release or attack phase may change the overall level of the signal. You can compensate for this by adjusting the Out Level slider.
Generally, you’ll find that Attack Time values of around 20 ms and Release Time values of 1500 ms are good to start with. Then adjust them for the type of signal that you’re processing.
The Lookahead slider defines how far into the future of the incoming signal Enveloper looks, in order to anticipate future events. You generally won’t need to use this feature, except when processing signals with extremely sensitive transients. If you do raise the Lookahead value, you may need to adjust the Attack Time to compensate.
In contrast to a compressor or expander, Enveloper operates independently of the absolute level of the input signal—but this works only if the Threshold slider is set to the lowest possible value.