Phase Distortion controls in Final Cut Pro
The Phase Distortion effect is based on a modulated delay line, similar to a chorus or flanger effect (see Intro to modulation effects in Final Cut Pro). Unlike these effects, however, the delay time is not modulated by a low-frequency oscillator (LFO), but rather by a lowpass-filtered version of the input signal itself, using an internal side chain. This means that the incoming signal modulates its own phase position.
The input signal only passes the delay line and is not affected by any other process. The Mix parameter blends the effect signal with the original signal.
For information about adding the Phase Distortion effect to a clip and showing the effect’s controls, see Add Logic effects to clips in Final Cut Pro.
Monitor button: Turn on to hear the input signal in isolation. Turn off to hear the mixed signal.
Cutoff knob and field: Set the (center) cutoff frequency of the lowpass filter.
Resonance knob and field: Emphasize frequencies surrounding the cutoff frequency.
Display: Shows the impact of parameters on the signal.
Intensity knob and field: Set the amount of modulation applied to the signal.
Phase Reverse button: Turn on to reduce the delay time on the right channel when input signals that exceed the cutoff frequency are received. Available only for stereo instances of the Phase Distortion effect.
Delay slider and field: Set the maximum delay time.
Mix slider and field: Set the percentage of the effect signal mixed with the original signal.