
Use Ultrabeat oscillator 2 sample mode in MainStage
In sample mode, oscillator 2 uses an audio file as a sound source.

Sample mode parameters
Sample Name display: Use to load and unload samples or to display the loaded sample in the Finder. Click the arrow in the upper-left corner of the waveform display to open.
Max/Min sliders: Move to set the start point of the sample—depending on the dynamics (incoming velocity level) of the performance.
Min: Determines the start point of the sample at the minimum velocity level (velocity = 1).
Max: Determines the start point of the sample at the maximum velocity level (velocity = 127).
Note: If Min and Max are set to the same value, velocity has no effect on the sample start point.
Playback Direction button: Change the playback direction of the sample (forward or backward).
Sample Layer sliders: Ultrabeat samples and sounds imported from sampler instruments often have different layers that are dynamically switched by incoming MIDI note velocities. The precise sample layer that incoming velocity values switch to is determined by the green Layer slider (Min) or the blue Layer slider (Max).
The Min slider determines which sample layer is triggered at a MIDI note velocity = 1.
The Max slider determines which sample layer is triggered at a MIDI note velocity = 127.
Note: If you have loaded a single sample that does not have multiple layers, the Vel Layer slider has no effect.