Mac Studio (2023) Battery

Before You Begin

Remove the following parts before you begin:

Tools

  • Nylon probe (black stick)

  • Torx T5 screwdriver

Important

This model requires a BR2032 battery. Replacement batteries can be purchased from electronics supply retailers.

Removal

  1. Use the T5 screwdriver to remove the two T5 screws (923-07617) from the battery cover.

  2. Lift the battery cover with the battery off the logic board.

  3. Turn over the battery cover. Use the black stick to lift the battery out of the cover.

Reassembly

Warning

Install only a BR2032 battery. There’s a risk of explosion if the battery is installed incorrectly or replaced with an incorrect type of battery. Dispose of used batteries according to local environmental laws and guidelines.

  1. Insert the positive side of the battery into the battery cover (1). Once the battery is installed, the negative side should be visible (2).

  2. Turn over the battery cover with the battery and position it on the logic board. Align the screw cutouts in the battery cover with the screw holes in the logic board.

  3. Use the T5 screwdriver to reinstall the two T5 screws (923-07617).

    • Note: 923-07617 is a kit that includes the screws and battery cover.

Reinstall the following parts to complete reassembly:

Published Date: