iPad Pro 11-inch (M4) Top Button
Before You Begin
Warning
Read Battery Safety and follow workspace and battery handling guidelines before you begin.
Remove the following part before you begin:
Tools
11-inch repair tray
Adhesive removal tool
ESD-safe tweezers
Ethanol wipes or isopropyl alcohol (IPA) wipes
JCIS bit for crosshead screws
Nitrile or lint-free gloves
Nylon probe (black stick)
Torque driver (black, 0.35 kgf cm)
Torque driver (green, 0.45 kgf cm)
Refer to a full list of tools required for all repairs.

Removal
Note: If you’ve already completed the removal steps, skip to reassembly.
Use a torque driver and the JCIS bit to remove three crosshead screws from the camera connector cowling. Set aside the screws. Remove the cowling and save it for reassembly.
Use a torque driver and the JCIS bit to remove two crosshead screws from the top button bracket. Set aside the screws.
Wi-Fi models only: Remove two additional crosshead screws from the antenna coaxial cable grounding clips. Set aside the screws.
Disconnect the camera flex cable and top button flex cable:
Lift the end of the camera flex cable off the connector and gently move it out of the way.
Lift the end of the top button flex cable off the connector. Then gently peel the top button flex cable off the enclosure.
Use the adhesive removal tool to break the glue between the top button bracket and enclosure. Then pry the bracket and top button out of the enclosure.
Wi-Fi models only: Gently lift the antenna coaxial cable and slide the bracket and top button out from under it.
Reassembly
Use the black stick to break away any remaining glue from the top button area in the enclosure. Then use ethanol wipes or IPA wipes to clean any residual adhesive.
Slide the replacement top button and bracket into the enclosure.
Wi-Fi models only: Gently lift the antenna coaxial cable and slide the top button and bracket under the cable and into the top button area of the enclosure.
Press the top button to ensure that it clicks as expected. If the button clicks as expected, continue to step 4. If it doesn't, remove the top button and bracket. Then repeat reassembly steps 1 through 3.
Use the black torque driver and JCIS bit to install two new crosshead screws (452-05786) into the top button bracket.
Wi-Fi models only: Use the green torque driver and JCIS bit to install two additional new crosshead screws into the antenna coaxial cable grounding clips:
One screw (452-09562) (1)
One screw (452-02923) (2)
Connect the top button flex cable and camera flex cable:
Press the end of the top button flex cable to the connector (1). Then gently press along the area shown (2) to adhere the top button flex cable to the enclosure.
Position the grounding foam on top of the top button flex cable (1). Then press the end of the camera flex cable to the connector (2).
Position the camera connector cowling over the ends of the flex cables. Then use the black torque driver and JCIS bit to install two new crosshead screws into the camera connector cowling:
One screw (452-05348) (1)
One screw (452-06440) (2)
Use the green torque driver and JCIS bit to install one new crosshead screw (452-10354) into the camera connector cowling.
Reinstall the following part to complete reassembly: