Mac Studio (2025) Speaker
Before You Begin
Warning
Read Mac Electrical Safety and follow workspace handling guidelines before you begin.

Remove the following parts before you begin:
Tools
Adjustable torque driver (10–34 Ncm)
ESD-safe tweezers
Nylon probe (black stick)
Torx Plus 5IP 50 mm bit
Refer to a full list of tools required for all repairs.
Removal
Note: If you’ve already completed the removal steps, skip to reassembly.
Use the 10–34 Ncm adjustable torque driver and 5IP bit to remove the two 5IP screws (923-12498) from the speaker.
Slightly lift the speaker. Then use the flat end of the black stick to lift the end of the speaker flex cable off the connector on the logic board.
Remove the speaker from the housing.
Reassembly
Position the speaker over the logic board.
Use the flat end of the black stick to press the end of the speaker flex cable to the connector (1).
Align the screw holes in the speaker with the two speaker screw standoffs on the logic board (2).
Set the torque value on the 10–34 Ncm adjustable torque driver to 13 Ncm. Then use the adjustable torque driver and 5IP bit to reinstall the two 5IP screws (923-12498) into the speaker.
Reinstall the following parts to complete reassembly: