Studio Display VESA Mount Adapter

Before You Begin

Danger

Ensure that the power cord is not plugged into an electrical outlet.

Remove the following parts before you begin:

Tools

  • Adjustable torque wrench (2.5–25 Nm)

  • Alignment pins for stand and VESA mount adapter

  • Torx Plus 20IP 70 mm bit

Removal

  1. Lay the display flat on a table.

  2. Insert the 20IP bit into the 2.5–25 Nm adjustable torque wrench. Use the adjustable torque wrench and 20IP bit to remove the seven 20IP screws (452-06742).

  3. Lift the housing from the mount.

Reassembly

Important

  • If you’re installing a replacement VESA mount adapter, use the screws included with the replacement VESA mount adapter.

  • To replace the VESA mount adapter with a tilt-adjustable stand, follow the reassembly steps in Tilt-Adjustable Stand.

  • To replace the VESA mount adapter with a tilt- and height-adjustable stand, follow the reassembly steps in Tilt- and Height-Adjustable Stand.

  1. Insert the flange into the mount adapter.

  2. Install two alignment pins into the flange as shown.

  3. Use the alignment pins to position the display onto the mount adapter.

  4. Use the 2.5–25 Nm adjustable torque wrench and 20IP bit to partially reinstall five 20IP screws (452-06742) in the order shown.

  5. Keep the 20IP bit in the 2.5–25 Nm adjustable torque wrench. Set the torque value to 3.1 Nm.

  6. Use the adjustable torque wrench and 20IP bit to fully reinstall the five 20IP screws in the order shown.

  7. Remove the two alignment pins. Ensure that the 2.5–25 Nm adjustable torque wrench is still set to 3.1 Nm.

  8. Use the adjustable torque wrench and 20IP bit to fully reinstall the two 20IP screws as shown.

Reinstall the following parts to complete reassembly:

Published Date: