MacBook Neo Keyboard with Touch ID

Before You Begin

Warning

Read Battery Safety and follow workspace and battery handling guidelines before you begin.

Remove the following parts before you begin:

Tools

  • ESD-safe tweezers

  • Nylon probe (black stick)

  • Torque driver (blue, 0.65 kgf cm)

  • Torx Plus 1IP 44 mm half-moon bit

Refer to a full list of tools required for all repairs.

Important

Discard screws according to your local recycling guidelines.

Removal

Note: If you’ve already completed the removal steps, skip to reassembly.

  1. Use the blue torque driver and 1IP bit to remove the 1IP screws (452-13103) from the keyboard.

    • For ANSI or ISO keyboards with Touch ID: 41 screws

    • For JIS keyboards with Touch ID: 42 screws

  2. Lift the keyboard with Touch ID out of the top case as shown.

    • Caution: Be careful not to damage the microphone flex cable while lifting the keyboard from the top case. Damaging the microphone flex cable will require a top case replacement.

Reassembly

Important

The keyboard replacement kit includes 50 keyboard screws. There will be spare screws after installation.

  1. Position the replacement keyboard with Touch ID in the top case.

    • Caution: To avoid damaging the microphone flex cable, use the keyboard flex cable to clear the microphone flex cable while positioning the keyboard as shown. Damaging the microphone flex cable will require a top case replacement.

  2. Use the blue torque driver and 1IP bit to install two new 1IP screws (452-13103) into the keyboard with Touch ID board as shown.

  3. Use the blue torque driver and 1IP bit to install 18 new 1IP screws (452-13103) into the keyboard with Touch ID board as shown.

  4. Use the blue torque driver and 1IP bit to install the remaining new 1IP screws (452-13103) into the keyboard with Touch ID board, starting with the top row of screws and following the path shown.

    • For ANSI or ISO keyboards with Touch ID board: 25 screws

    • For JIS keyboards with Touch ID board: 26 screws

    • Important:

      • The image below shows an ANSI/ISO keyboard. The screw configuration for a JIS keyboard will be slightly different, but the procedure is the same.

      • The keyboard replacement kit comes with 50 keyboard screws. There will be spare screws after you complete steps 2 through 4.

  5. Reinstall the Touch ID board.

  6. Complete the reassembly steps in Keyboard Shield to install a replacement keyboard shield.

Reinstall the following parts to complete reassembly:

Published Date: