Adjust volume, pan, and sends with Logic Remote on iPad
You use the Logic Remote Mixer controls to adjust a channel strip’s volume level, pan position, and send levels. You can also control the overall volume of a concert.
In Logic Remote, do one of the following:
Drag the Volume fader up or down to raise or lower the volume.
Double-tap the Volume fader (or the area above or below the fader) to reset the volume to a neutral setting (0 dB).
Tap the peak level display above one of the level meters to reset the all the peak level displays.
Tip: To check the volume level at any point, tap the area above or below the Volume fader. The volume level momentarily replaces the channel strip number.
Do one of the following:
Drag the Master Volume fader up or down to raise or lower the volume.
Double-tap the Master Volume fader (or the area above or below the fader) to reset the volume to a neutral setting (0 dB).
Drag the Master Volume slider in the control bar right or left to raise or lower the volume.
In Logic Remote, tap Pan & Volume to access the Pan/Balance knobs, then do one of the following:
Drag the Pan/Balance knob left or right.
Double-tap the Pan/Balance knob to reset it to the center position.
In Logic Remote, tap Sends 1-4 or Sends 5-8 to access the Send Level knobs.
Note: Sends 5-8 is only available if there are more than four sends on any channel strip.
Drag the Send Level knob up to increase the level, or down to decrease the level.
In Logic Remote, touch and hold a send, then choose a destination from the pop-up menu.