MacBook Air (13-inch, M3, 2024) Left Speaker with Antenna

Before You Begin

 Warning

Read Battery Safety and follow workspace and battery handling guidelines before you begin.

Remove the following parts before you begin:

Tools

  • Adjustable torque driver (10–34 Ncm)

  • Antenna tool

  • ESD-safe tweezers

  • Nylon probe (black stick)

  • Torque driver (blue, 0.65 kgf cm)

  • Torx Plus 3IP 44 mm half-moon bit

  • Torx Plus 4IP 25 mm bit

  • Torx Plus 5IP 50 mm bit

Refer to a full list of tools required for all repairs.

 Caution

This procedure requires System Configuration. After you've completed all removal and reassembly steps, learn how to initiate the System Configuration process.

Important

If you replace the left speaker with antenna, you must also replace the right speaker with antenna.

Removal

  1. Use the blue torque driver and 3IP bit to remove the four 3IP screws (923-10367) from the left speaker connector cowling and antenna coaxial cables connector cowling.

  2. Remove the left speaker connector cowling and antenna coaxial cables connector cowling. Save the cowlings for reassembly.

  3. Use the black stick to lift the end of the left speaker flex cable off the connector.

  4. Use the black stick to lift the end of the left antenna coaxial cable off the connector.

  5. Use the 10–34 Ncm adjustable torque driver and 4IP bit to remove the two 4IP screws (923-10383) from the left speaker with antenna.

  6. Use the adjustable torque driver and 5IP bit to remove the 5IP screw (923-10373) from the left speaker with antenna.

  7. Use the black stick to tilt up the right side of the left speaker with antenna (1). Then slide the left speaker with antenna to the right and remove it from the top case (2).

Reassembly

  1. Insert the left side of the left speaker with antenna into the top case as shown (1). Then lower the left speaker with antenna into the top case (2).

  2. Set the torque value on the 10–34 Ncm adjustable torque driver to 11.5 Ncm. Then use the adjustable torque driver and 5IP bit to reinstall the 5IP screw (923-10373) into the left speaker with antenna.

  3. Set the torque value on the adjustable torque driver to 16 Ncm. Then use the adjustable torque driver and 4IP bit to reinstall the two 4IP screws (923-10383) into the left speaker with antenna in the order shown.

  4. Use the black stick or ESD-safe tweezers to position the end of the left antenna coaxial cable over the connector. Then use the blunt end of the antenna tool to press the end of antenna coaxial cable to the connector.

  5. Press the end of the left speaker flex cable to the connector.

  6. Position the antenna coaxial cables connector cowling and left speaker connector cowling.

  7. Use the blue torque driver and 3IP bit to reinstall the four 3IP screws (923-10367) into the cowlings.

Reinstall the following parts to complete reassembly:

 Caution

After you've completed all removal and reassembly steps, learn how to initiate the System Configuration process.

Published Date: