iMac (24-inch, M1, 2021, Two ports) Battery Board and Batteries

Before You Begin

Remove the following part before you begin:

Tools

  • ESD-safe tweezers

  • Ethanol wipes or isopropyl alcohol (IPA) wipes

  • Nylon probe (black stick)

  • Support wedges

Important

This model requires two CR2016 batteries. Replacement batteries can be purchased from electronics supply retailers.

Removal

  1. Position the housing with the back facedown and the top closest to you.

  2. Position the pointed end of the black stick underneath the battery cable and close to the connector. Hold the battery cable in place against the black stick and lift the end of the battery cable off the connector.

  3. Use ESD-safe tweezers to grasp the battery adhesive tab and gently peel it from the battery board.

  4. Use ESD-safe tweezers to grasp the battery adhesive tab. Keep the tweezers close and parallel to the housing. Then slowly twist the tweezers to wrap the adhesive around them.

    •  Caution: Don’t pull up the battery adhesive strip.

  5. Pull the tweezers down. As the battery adhesive strip stretches, continue to slowly pull and twist the tweezers until you have removed the entire strip.

    • Note: Hold the battery board in place as it loosens.

    •  Caution: If the battery adhesive strip breaks and can’t be retrieved, don’t forcibly pry the battery board. Stop the repair and reassemble the computer. For service, visit support.apple.com/repair.

  6. Remove the battery board from the housing and place it on an ESD-safe surface.

  7. Turn over the battery board. Peel up any remaining adhesive. Use an ethanol wipe or IPA wipe to clean any adhesive residue from the back of the battery board.

  8. Use a black stick to gently push the batteries outward to remove the batteries from the battery board.

Reassembly

 Warning: Install only a CR2016 battery. There is a risk of explosion if the battery is installed incorrectly or replaced with an incorrect type of battery. Dispose of used batteries according to local environmental laws and guidelines.

  1. If you removed the batteries or are installing new batteries, slide the positive (+) side of the batteries up into the battery compartments on the battery board.

  2. If you’re reinstalling the same battery board, apply a new adhesive strip to the back of the battery board as shown. Fold down the adhesive tab (1) between the batteries.

  3. Peel the large blue release liner from the back of the battery board to expose the battery board adhesive.

  4. Align the top edge of the battery board with the cutout in the housing. Then lay down the battery board.

  5. Press and hold the battery board for 15 seconds in the areas shown in blue to adhere it to the housing.

    •  Caution: Don’t press on the battery compartments.

  6. Press the end of the battery cable to the connector.

Reinstall the following part to complete reassembly:

Published Date: