MacBook Pro (14-inch PROLED XDR, M5 Pro or M5 Max) Display Hinge Covers Reassembly

Repair procedure with reassembly steps.

Before You Begin

Warning

Read Battery Safety and follow workspace and battery handling guidelines before you begin.

Tools

  • Adjustable torque driver (10–34 Ncm)

  • Torx Plus 5IP 50 mm bit

Note: The tools list includes tools needed for removal and reassembly. Refer to a full list of tools required for all repairs.

Reassembly

  1. Position one display hinge cover in the top case.

  2. Set the torque value on the 10–34 Ncm adjustable torque driver to 10 Ncm.

  3. Press the display hinge cover toward the vent/antenna module and hold it in place. Then use the adjustable torque driver and 5IP bit to reinstall the two 5IP screws (923-15326) into the hinge cover.

    • Important: The hinge cover should line up evenly with the arch feature on the top case and with the side of the enclosure to prevent interference with the vent/antenna module and the display modules.

  4. Repeat step 1 to step 3 for the other hinge cover.

Reinstall the following parts to complete reassembly:

Published Date: