iMac (24-inch, M1, 2021, Four ports) Wi-Fi and Bluetooth Antenna

Before You Begin

Remove the following parts before you begin:

Tools

  • Antenna tool

  • Nylon probe (black stick)

  • Support wedges

  • Torx T3 screwdriver

Removal

  1. Use the T3 screwdriver to remove the four T3 screws from the Wi-Fi and Bluetooth antenna.

    • Note: The bottom screw has a larger head than the top three screws.

  2. Use the T3 screwdriver to remove the T3 screw (923-05174) from the antenna grounding clip on the logic board.

  3. Use the antenna tool to lift the end of the Wi-Fi and Bluetooth antenna from the logic board.

  4. Use the black stick to peel the Wi-Fi and Bluetooth antenna cable tape from the speaker and housing.

  5. Carefully lift the cable out of the channel in the speaker.

Reassembly

  1. Position the Wi-Fi and Bluetooth antenna in the bottom left of the housing as shown.

    • Important: Ensure that the antenna cable tape covers the etched areas on the housing as shown.

  2. Route the Wi-Fi and Bluetooth antenna cable through the channel in the speaker.

  3. Use the flat end of the antenna tool to press the end of the Wi-Fi and Bluetooth antenna to the logic board.

  4. Use the T3 screwdriver to reinstall the T3 screw (923-05174) into the antenna grounding clip.

  5. Press the antenna cable tape back onto the speaker and housing.

    • Important: If installing a replacement Wi-Fi and Bluetooth antenna, peel off the adhesive release liners from the tape before adhering it to the speaker and housing.

  6. Use the T3 screwdriver to reinstall the four T3 screws into the Wi-Fi and Bluetooth antenna.

Reinstall the following parts to complete reassembly:

Published Date: