iMac (24-inch, 2023) Display Backlight Flex Cable

Before You Begin

Remove the following parts before you begin:

Note

This procedure is shared between the iMac (24-inch, 2023, Two ports) and iMac (24-inch, 2023, Four ports). Images in this procedure may show one model. However, the steps to perform the repair are the same for both.

Tools

  • Support wedge kit (076-00507)

Refer to a full list of tools required for all repairs.

Removal

  1. Position the housing with the logic board facing up.

  2. Peel off the polyester film tape from the end of the display backlight flex cable. Save the polyester film tape for reassembly.

  3. Squeeze both sides of the end of the display backlight flex cable and pull it straight out of the connector.

Reassembly

  1. Slide the end of the display backlight flex cable into the connector.

  2. Reinstall the polyester film tape onto the display backlight flex cable connector.

    • Important: Install new polyester film tape whenever it’s provided with a replacement part.

Reinstall the following parts to complete reassembly:

Published Date: