MacBook Air (M1, 2020) Embedded DisplayPort Flex Cable with Connector Cowling

Before You Begin

Remove the following parts before you begin:

Tools

  • Nylon probe (black stick)

  • Torx T3 screwdriver

Removal

  1. Turn over the logic board.

  2. Use the T3 screwdriver to remove the two T3 screws (923-02890) from the eDP flex cable with connector cowling.

  3. Use the flat end of the black stick to lift the end of the eDP flex cable with connector cowling off the connector.

Reassembly

  1. Use the flat end of the black stick to press the end of the eDP flex cable with connector cowling to the connector.

  2. Use the T3 screwdriver to reinstall the two T3 screws (923-02890) into the eDP flex cable with connector cowling.

  3. Turn over the logic board.

Reinstall the following parts to complete reassembly:

Published Date: