MacBook Air (13-inch, M4, 2025) Lid Angle Sensor
Before You Begin
Warning
Read Battery Safety and follow workspace and battery handling guidelines before you begin.
Remove the following parts before you begin:
Tools
Nylon probe (black stick)
Torque driver (blue, 0.65 kgf cm)
Torx Plus 1IP 44 mm half-moon bit
Torx Plus 3IP 44 mm half-moon bit
Refer to a full list of tools required for all repairs.

Caution
This procedure requires System Configuration. After you've completed all removal and reassembly steps, learn how to initiate the System Configuration process.
Note: This procedure may show images of different models, but the steps are the same. Ensure that you use the correct tools for the model you’re repairing.
Removal
Note: If you’ve already completed the removal steps, skip to reassembly.
Use the blue torque driver and 3IP bit to remove the two 3IP screws (923-12557) from the audio board connector cowling.
Remove the audio board connector cowling and save it for reassembly.
Lift the end of the lid angle sensor flex cable off the connector.
Loosen the adhesive and peel the lid angle sensor flex cable from the audio board. Note: Use the black stick as needed to disengage the adhesive between the lid angle sensor flex cable and the top case.
Use the blue torque driver and 1IP bit to remove one 1IP screw (923-12568) from the lid angle sensor.
Remove the lid angle sensor from the top case.
Reassembly
Position the clip on the lid angle sensor flex cable so the tab and screw hole on the clip are aligned with the tab slot and screw hole on the hinge cover.
Use the blue torque driver and 1IP bit to reinstall the 1IP screw (923-12568) into the lid angle sensor.
Press the end of the lid angle sensor flex cable to the connector (1).
Gently press the lid angle sensor flex cable to adhere it to the audio board (2).
Important: If you’re installing a replacement lid angle sensor flex cable, peel off the adhesive backing first.
Position the audio board connector cowling over the end of the lid angle sensor flex cable.
Use the blue torque driver and 3IP bit to reinstall the two 3IP screws (923-12557) into the audio board connector cowling.
Reinstall the following parts to complete reassembly:
Caution
After you’ve completed all removal and reassembly steps, learn how to initiate the System Configuration process.
If you replaced the lid angle sensor, close the display for 20 seconds when prompted during the System Configuration process. If the display isn’t fully closed during the process, you'll need to install another new lid angle sensor. The computer will play a startup sound (chime) when the process is complete.