iPad (A16) Camera
Before You Begin
Warning
Read Battery Safety and follow workspace and battery handling guidelines before you begin.
Remove the following parts before you begin:
Tools
1.5 mm slotted screwdriver
11-inch repair tray
ESD-safe tweezers
Ethanol wipes or isopropyl alcohol (IPA) wipes
JCIS bit for crosshead screws
Nitrile or lint-free gloves
Nylon probe (black stick)
Torque driver (gray, 0.55 kgf cm)
Torque driver (green, 0.45 kgf cm)
Refer to a full list of tools required for all repairs.

Removal
Note: If you’ve already completed the removal steps, skip to reassembly.
If you're replacing the camera in a Wi-Fi model, continue to step 2. If you're replacing the camera in a Wi-Fi + Cellular model, skip to step 3.
Wi-Fi models only: Use a torque driver and the JCIS bit to remove the crosshead screw from the camera connector cowling. Set aside the screw. Then remove the cowling and save it for reassembly.
Wi-Fi + Cellular models only: Use a torque driver and the JCIS bit to remove two crosshead screws, one from the top button flex cable and one from the camera connector cowling. Set aside the screws. Then remove the cowling and save it for reassembly.
Lift the end of the camera flex cable off the connector.
Wi-Fi + Cellular models only: Lift the end of the top button flex cable off the connector.
Wi-Fi + Cellular models only: Peel the grounding tape off the camera.
Use the 1.5 mm slotted screwdriver to pry the camera out of the enclosure.
Reassembly
Caution
Put on the gloves to prevent contamination of the camera lenses.
Remove adhesives from the camera opening of the enclosure. Then use an ethanol wipe or IPA wipe to clean any remaining residue.
Important: Don't touch the lens while cleaning the residue.
Wi-Fi + Cellular models only: Peel the copper tape off the enclosure. Then use an ethanol wipe or IPA wipe to clean any remaining residue.
Apply new camera adhesive in the camera opening of the enclosure.
Inspect the replacement camera. If the protective cover on the camera lens or the camera assembly is damaged, replace the camera. Use ESD-safe tweezers to remove the protective cover from the camera.
Caution: Don’t touch the camera lens after you remove the protective cover.
Position the camera in the enclosure. Then gently press the camera for 10 seconds to adhere it to the enclosure.
Press the end of the camera flex cable to the connector.
Wi-Fi + Cellular models only: Install new copper tape on the enclosure.
Wi-Fi + Cellular models only: Install new grounding tape over the camera.
Wi-Fi + Cellular models only: Press the end of the top button flex cable to the connector.
Position the camera connector cowling over the end of the camera flex cable.
Use the green torque driver and JCIS bit to install one new crosshead screw (452-11910) into the camera connector cowling.
Wi-Fi + Cellular models only: Use the gray torque driver and JCIS bit to install one new crosshead screw (452-11907) into the top button flex cable.
Reinstall the following parts to complete reassembly: