MacBook Pro (13-inch, M1, 2020) Embedded DisplayPort Flex Cable with Connector Cowling

Before You Begin

Remove the following parts before you begin:

Tools

  • Nylon probe (black stick)

  • Torx T3 screwdriver

Removal

  1. Peel back the polyester film tape from the eDP flex cable with connector cowling to access the two T3 screws (923-05199).

  2. Use the T3 screwdriver to remove the two T3 screws from the eDP flex cable with connector cowling.

  3. Use the flat end of the black stick to lift the end of the eDP flex cable with connector cowling off the connector.

Reassembly

  1. Press the end of the eDP flex cable with connector cowling to the connector.

  2. Use the T3 screwdriver to reinstall the two T3 screws (923-05199) into the cowling.

  3. Press the polyester film tape onto the screws.

Reinstall the following parts to complete reassembly:

Published Date: