iPad Air 13-inch (M4) Camera

Before You Begin

Warning

Read Battery Safety and follow workspace and battery handling guidelines before you begin.

Remove the following part before you begin:

Tools

  • 1.5 mm slotted screwdriver

  • Crosshead 44 mm half-moon bit

  • ESD-safe tweezers

  • Ethanol wipes or isopropyl alcohol (IPA) wipes

  • Nitrile or lint-free gloves

  • Nylon probe (black stick)

  • Torque driver (black, 0.35 kgf cm)

Refer to a full list of tools required for all repairs.

Removal

Note: If you’ve already completed the removal steps, skip to reassembly.

  1. Use a torque driver and crosshead bit to remove the two crosshead screws from the camera connector cowling. Then remove the cowling and save it for reassembly.

  2. Lift the end of the camera flex cable off the connector.

  3. Use the 1.5 mm slotted screwdriver to pry the camera out of the enclosure.

    • Caution: Ensure that the tip of the screwdriver is wedged between the side of the camera and the enclosure before you attempt to pry the camera out of the enclosure.

Reassembly

Caution

Put on the gloves to prevent contamination of the camera lenses.

  1. Remove adhesive from the camera opening of the enclosure. Then use an ethanol wipe or IPA wipe to clean any residual adhesive.

    • Important: Don't touch the lens while cleaning the residual adhesive.

  2. Apply new camera adhesive in the camera opening of the enclosure.

  3. Inspect the replacement camera. If the protective cover on the camera lens or the camera assembly is damaged, replace the camera. Use ESD-safe tweezers to remove the protective cover from the camera.

    • Caution: Don’t touch the camera lens after you remove the protective cover.

    • A foam pad may be preinstalled on the camera flex cable. If it's not preinstalled, adhere the foam pad to the camera flex cable as shown before you remove the protective cover.

  4. Position the camera in the enclosure. Then gently press the camera for 10 seconds to adhere it to the enclosure.

  5. Remove the liner from the foam pad. Then press the end of the camera flex cable to the connector.

  6. Position the camera connector cowling over the end of the camera flex cable. Then use the black torque driver and crosshead bit to install two new crosshead screws (1, 2) into the cowling.

    • One screw (452-06436) (1)

    • One screw (452-05343) (2)

Reinstall the following part to complete reassembly:

Published Date: