iPhone 15 Plus Camera

Before You Begin

Warning

Read Battery Safety and follow workspace and battery handling guidelines before you begin.

Remove the following part before you begin:

Tools

  • 6.7-inch repair tray

  • Adjustable torque driver (10–34 Ncm)

  • ESD-safe tweezers

  • JCIS bit for adjustable torque driver

  • Nitrile or lint-free gloves

  • Nylon probe (black stick)

Caution

Avoid touching the camera lenses, TrueDepth camera grounding springs, or nearby parts.

Important

  • If you replace this part, it is recommended to run Repair Assistant in order to finish the repair. Repair Assistant will be available on the device after you’ve completed all reassembly steps.

  • If the iPhone has an mmWave antenna, you’ll need to disconnect an extra flex cable. Check the side of the iPhone to determine if it has an mmWave antenna.

Removal

Caution

It's recommended to put on the gloves and to cover the camera lenses to prevent contamination of the camera lenses.

  1. Use the adjustable torque driver and JCIS bit for adjustable torque driver to remove the three crosshead screws from the camera cowling. Set aside the screws.

    • Caution: Avoid touching the camera lenses.

  2. Lift the ends of the two camera flex cables off the connectors.

    • Important: If your iPhone has an mmWave antenna, lift the end of the mmWave antenna flex cable off the connector as shown with a dashed outline.

  3. Use the black stick to loosen and separate the adhesive between the lower camera flex cable and the camera well. Then lift the camera and the camera flex cables out of the enclosure. Important: If the iPhone has an mmWave antenna, lift the mmWave antenna flex cable and place it slightly to the side.

    • Caution: The mmWave antenna stays in the enclosure. Don't remove it.

Reassembly

Caution

To avoid contamination of the lenses, don’t remove the camera cap or the protective lens covers until you are ready to position the camera in the enclosure.

  1. Put on the gloves to prevent contamination of the camera lenses.

  2. Position the camera in the enclosure with the lenses faceup.

    • Important: Ensure that the camera flex cables are inside the channel between the battery and the camera well.

    • Important: Ensure that the camera grounding spring is not broken or bent. If it is, replace the camera.

    • Important: If the iPhone has an mmWave antenna, ensure that the mmWave antenna flex cable is positioned between the camera sidewall and the camera flex cables.

  3. Press the ends of the two camera flex cables to the connectors.

    • Important: If the iPhone has a mmWave antenna, press the end of the mmWave antenna flex cable to the connector as shown with the dashed outline.

  4. Insert the JCIS bit for adjustable torque driver into the 10–34 Ncm adjustable torque driver. Set the torque value to 13 Ncm. Use the adjustable torque driver and JCIS bit to install three new crosshead screws (923-09822) into the camera.

  5. Follow back glass reassembly steps 1 through 26. Then continue to step 6.

  6. Inspect the camera lenses for contamination such as dust, scratches, or smudges. If there is contamination, remove the back glass and complete camera removal and reassembly with another replacement camera.

Reinstall the following part to complete reassembly:

Important

After you’ve completed all reassembly steps, Repair Assistant will be available on the device and is recommended to finish the repair. Learn how to initiate Repair Assistant.

Published Date: