Studio Display XDR AC Power Inlet

Before You Begin

Danger

Ensure that the AC power cord isn't plugged into an electrical outlet.

Remove the following parts before you begin:

Tools

  • Adjustable torque driver (0.3–1.2 Nm)

  • Adjustable torque driver (10–34 Ncm)

  • Nylon probe (black stick)

  • Torx Plus 6IP 25 mm bit

Refer to a full list of tools required for all repairs.

Removal

Note: If you've already completed the removal steps, skip to reassembly.

  1. Use the 0.3–1.2 Nm adjustable torque driver and 6IP bit to remove the two 6IP screws (923-14046) from the top of the AC power inlet.

  2. Use the 10–34 Ncm adjustable torque driver and 6IP bit to remove the six 6IP screws (923-14045) from the perimeter of the AC power inlet.

  3. Remove the AC power inlet from the housing.

Reassembly

  1. Position the AC power inlet in the housing.

  2. Set the torque value on the 10-34 Ncm adjustable torque driver to 14.5 Ncm. Use the adjustable torque driver and 6IP bit to reinstall six 6IP screws (923-14045) into the perimeter of the AC power inlet.

  3. Set the torque value on the 0.3–1.2 Nm adjustable torque driver to 0.45 Nm. Use the adjustable torque driver and 6IP bit to reinstall two 6IP screws (923-14046) into the top of the AC power inlet.

Reinstall the following parts to complete reassembly:

Published Date: