Mac Studio (2022) Speaker

Before You Begin

Remove the following parts before you begin:

Tools

  • Adjustable torque driver (10-34 Ncm)

  • Nylon probe (black stick)

  • Torx T5 bit

  • Torx T5 screwdriver

Removal

  1. Use the T5 screwdriver to remove the two T5 screws (923-07104) from the speaker.

  2. Slightly lift the speaker. Use the flat end of the black stick to lift the end of the speaker flex cable off the connector on the logic board.

  3. Lift the speaker out of the housing.

Reassembly

  1. Position the speaker over the logic board.

  2. Use the flat end of the black stick to press the end of the speaker flex cable to the connector (1).

  3. Align the screw holes in the speaker with the two speaker standoff screws on the logic board (2).

  4. Insert the Torx T5 bit into the 10–34 Ncm adjustable torque driver. Set the torque value to 13 Ncm.

  5. Use the adjustable torque driver and Torx T5 bit to reinstall the two T5 screws (923-07104) into the speaker.

Reinstall the following parts to complete reassembly:

Published Date: