Studio Display XDR Housing

Before You Begin

Danger

Ensure that the AC power cord isn’t plugged into an electrical outlet.

Caution

This procedure requires System Configuration. To perform System Configuration you will need the following:

• The latest version of Apple Service Utility installed on an Apple silicon or Intel-based Mac with the Apple T2 Security Chip running macOS Sonoma 14.1 or later

• Internet access

• A USB-C charge cable or a USB-A to USB-C cable. The USB-C cable must support both power and data. Don’t use Thunderbolt 3 cables.

Remove the following parts before you begin:

• Display (stand) or display (VESA mount adapter)

• Logic board

• Left fan

• Right fan

• USB-C boards

• Power supply board

• Cables

• AC power inlet

• AC power cord

• Stand or VESA mount adapter

Tools

No tools are required for this procedure.

Removal

Note: If you’ve already completed the removal steps, skip to reassembly.

Caution

Place the housing on a clean, flat work surface or on a soft cloth to avoid damage.

There are no additional removal steps.

The housing includes the following nonremovable parts:

• Speakers

• Microphone

A replacement housing includes the following removable parts:

• Camera flex cable

• Microphone flex cable

• Display backlight power flex cable

• Screws for stand and VESA mount adapter

Reassembly

Reinstall the following parts to complete reassembly:

• Stand or VESA mount adapter

• AC power cord

• AC power inlet

• Cables

• Power supply board

• USB-C boards

• Right fan

• Left fan

• Logic board

• Display (stand) or display (VESA mount adapter)

Repair Completion

Caution

System Configuration is required if you replaced the logic board. You will initiate and complete System Configuration at the end of display reassembly. You will need a separate Mac with Apple Service Utility installed to perform System Configuration.