MacBook Air (15-inch, M3, 2024) Lid Angle Sensor

Before You Begin

Warning

Read Battery Safety and follow workspace and battery handling guidelines before you begin.

Important

If you replace this part, it’s recommended to run Repair Assistant in order to finish the repair. Repair Assistant will be available on the device after you’ve completed all reassembly steps.

Important

Before beginning the repair, ensure that the device is running macOS 15.3 or later.

Remove the following parts before you begin:

Tools

  • ESD-safe tweezers

  • Nylon probe (black stick)

  • Torque driver (blue, 0.65 kgf cm)

  • Torx Plus 1IP 44 mm half-moon bit

Refer to a full list of tools required for all repairs.

Removal

Note: If you’ve already completed the removal steps, skip to reassembly.

  1. Use the flat end of the black stick to lift the end of the lid angle sensor flex cable off the connector.

  2. Use the flat end of the black stick to move the lid angle sensor flex cable aside to access the 1IP screw (1).

  3. Use the blue torque driver and 1IP bit to remove the 1IP screw (923-08984) from the lid angle sensor (2).

  4. Remove the lid angle sensor from the top case.

Reassembly

  1. Align the slot and screw hole on the lid angle sensor flex cable with the pin and screw hole in the top case.

  2. Hold the lid angle sensor in position (1). Use ESD-safe tweezers to position the 1IP (923-08984) screw into the lid angle sensor (2). Then use the blue torque driver and 1IP bit to install the screw.

  3. Press the end of the lid angle sensor flex cable to the connector (1). Then lay the flex cable flat (2) as shown.

Reinstall the following parts to complete reassembly:

Important

Published Date: