MacBook Air (M1, 2020) Display

Before You Begin

Remove the following parts before you begin:

Tools

  • Torx T8 screwdriver

Important

If you replace this part, it’s recommended to run Repair Assistant in order to finish the repair. Repair Assistant will be available on the device after you’ve completed all reassembly steps.

Removal

  1. Open the display to a 90-degree angle. Then place the computer on the edge of the table with the display hanging down.

  2. Use the T8 screwdriver to remove the six T8 screws (923-03997) from the display hinges.

  3. Pull the display toward you about 15 degrees (1). Move the display away from you to allow the hinges to clear the edge of the top case. Then lift the display up and out of the top case (2).

Reassembly

Important

Ensure that you remove all protective liners and tape from a replacement display.

  1. Place the display on the top case.

    • Note: The display includes the TCON board.

  2. Ensure that the TCON board is inside the top case.

  3. Use the T8 screwdriver to partially reinstall the six T8 screws (923-03997) into the display hinges in the order shown.

  4. Close the display and adjust it until it’s flush with the top case.

  5. Use the T8 screwdriver to fully reinstall the six T8 screws into the display hinges.

Reinstall the following parts to complete reassembly:

Important

Depending on the part replaced, Repair Assistant may be available on the device to finish the repair. Learn how to initiate Repair Assistant. 

Published Date: