Repairing Damaged Display Mandrels
Before You Begin
Warning
Read Battery Safety and follow workspace and battery handling guidelines before you begin. Keep the battery cover installed over the battery cells throughout this repair.
Note: Replace the mandrel if it's damaged, torn, or separated during the main logic board or display assembly repair process.
Tools
Battery cover
Nylon probe (black stick)
Removal
Gently insert the black stick between the display clip and the mandrel. Release the adhesive with the black stick. Then peel the damaged mandrel off the display clip.
Reassembly
Remove the adhesive liner from the replacement mandrel.
Insert the mandrel into the channel on the top case from the hinge side with the adhesive side facing up.
Important: Press the mandrel into the channel until it's positioned firmly against the vent on the enclosure.
Position the display clip over the mandrel. Then align the screw holes on the clip with both screw bosses on the top case.
Important: Ensure that the bend in the flex cable is behind the mandrel and in the vent/antenna channel.
Press the display clip onto the replacement mandrel and clip it in place.
Important: Once clipped in place, press down along the length of the clip to ensure that the entire mandrel is adhered to the clip.
