MacBook Air (13-inch, M3, 2024) Top Case with Keyboard

Before You Begin

Warning

Read Battery Safety and follow workspace and battery handling guidelines before you begin.

Remove the following parts before you begin:

Tools

  • Torque driver (blue, 0.65 kgf cm)

  • Torx Plus 2IP 44 mm half-moon bit

  • Note: A replacement top case with keyboard includes the following additional parts and tools:

    • 2IP set screw

    • Battery adhesive

    • Gap offset kit

    • I/O connector cowling tape

    • Touch ID alignment kit

    • Touch ID board flexible cowling

    • Trackpad shims (oval)

    • Trackpad shims (round)

Refer to a full list of tools required for all repairs.

Removal

There are no additional removal steps.

Reassembly

A replacement top case with keyboard includes the following preinstalled parts:

  • Interposer board

  • Keyboard backlight flex cable

  • Keyboard and keyboard flex cable

  • Microphone and microphone flex cable

  • Open/close (AMR) sensor

  1. Use the blue torque driver and 2IP bit to partially install one new 2IP set screw (923-10385) into the replacement top case with keyboard with one clockwise rotation. You’ll adjust the 2IP set screw during the Touch ID board reassembly steps.

    • Important: Don’t fully install the 2IP set screw.

Reinstall the following parts to complete reassembly:

Published Date: