Mac Studio (2022) SSD Modules

Before You Begin

Caution

• This procedure requires System Configuration. After you’ve completed all removal and reassembly steps, learn how to initiate the System Configuration process.

• If you replace the SSD modules, you’ll need a separate Mac running the latest version of macOS or a separate Mac with Apple Configurator installed to restore the Mac before initiating the System Configuration process.

Important

SSD modules must be replaced in pairs except in a device with a 512 GB configuration, which has a single SSD module. This procedure shows the removal and reassembly of a single SSD module. However, the steps are the same for removing and reinstalling two SSD modules.

Removal

1. Place the computer as shown.

   

2. Use ESD-safe tweezers to peel the SSD module cover off the SSD module.

   • Important: A replacement SSD module cover is included with SSD module replacement parts. If you’re replacing the SSD module, discard the SSD module cover. If you’re removing the SSD module as part of another procedure, save the SSD module cover for reassembly.

   

3. Use the T8 screwdriver to remove the T8 screw (923-02313) from the SSD module.

   

4. Grasp the sides of the SSD module and firmly pull it from the SSD module connector.

   • Caution: Don’t tilt or lift the SSD module when removing it from the SSD module connector.

   

Reassembly

Important: If you’re installing a replacement SSD module, complete all reassembly steps. If you’re reinstalling the existing SSD module, skip to step 2.

1. Peel the temporary regulatory label off the back of the replacement SSD module before installing it.

   

2. Each SSD module has a serial number that ends in 00 or 01. Identify the corresponding SSD module connector for the SSD module.

   

3. Grasp the sides of the SSD module and firmly slide it into the SSD module connector.

   • Caution: Don’t tilt or lift the SSD module when inserting it into the SSD module connector.

   

4. Use the T8 screwdriver to reinstall the T8 screw (923-02313) into the SSD module.

   

5. If you’re reinstalling the existing SSD module, skip to reassembly step 6. If you’re installing a replacement SSD module, peel a replacement SSD module cover from the adhesive backing.

   

6. Position the SSD module cover over the SSD module and connector as shown. Then fold the three polyester film tabs over the edges of the SSD module connector. Press the tabs onto the sides of the connector.

   

Reinstall the following parts to complete reassembly:

• Internal frame

• Power supply

• Bottom cover

Caution

• After you’ve completed all removal and reassembly steps, learn how to initiate the System Configuration process.

• If you replaced the SSD modules, the computer won’t start up and the status indicator light will flash amber. Follow the instructions to restore the Mac. Then initiate the System Configuration process.