Languages

Archived - iMac (Early 2009): Memory specifications

Learn which kinds of memory you can use with your iMac (Early 2009) computer.

This article has been archived and is no longer updated by Apple.

The iMac (Early 2009) computer has two SDRAM slots in the bottom of the computer and comes with at least 2 GB DDR3 SDRAM installed as 1GB DIMMs into each slot.

The maximum amount of RAM you can install in the computer is 8 GB (a 4 GB SO-DIMM in each slot).

You can use any Small-Outline dual inline memory modules (SO-DIMMS) that meets all of these criteria:

  • PC3-8500
  • Unbuffered
  • Nonparity
  • 204-pin
  • 1066 MHz
  • DDR3 SDRAM

You can use RAM module sizes of 1 GB, 2 GB or 4GB in each slot.

DIMMs with any of the following features are not supported in the iMac (Early 2009) computer:

  • Registers or buffers
  • PLLs
  • ECC
  • Parity
  • EDO RAM

Always follow the upgrade instructions for memory installation as written. Never attempt to remove screws that are not listed in the upgrade instructions.

Additional Information

For more information about upgrading your iMac (Early 2009) memory, see iMac (Mid 2007) and later: Installing or replacing memory.

Last Modified: Aug 5, 2013
Helpful?
Yes
No
Not helpful Somewhat helpful Helpful Very helpful Solved my problem
Print this page
  • Last Modified: Aug 5, 2013
  • Article: HT3911
  • Views:

    184251
  • Rating:
    • 66.0

    (656 Responses)

Additional Product Support Information

Start a Discussion
in Apple Support Communities
See all questions on this article See all questions I have asked