Logic Studio: Empty IR created after deconvolution in Impulse Response Utility
Symptoms
Sometimes when you open a saved project in the Impulse Response Utility and deconvolve a previously recorded sweep, you may create an empty impulse response.
Products Affected
Logic Studio
Resolution
This may happen if you record a sweep, save, then close a project before deconvolving. When you reopen the project and press "Deconvolve", the recorded waveform disappears; if you create a Space Designer setting, the resulting IR file contains no audio.
To avoid this, always perform the deconvolution step in the same session you record the sweep.
Additional Information
This document will be updated as more information becomes available.
Rate this article: