Languages

Archived - eMac: How to Install or Replace Memory

This document explains installing or replacing memory.

Installation Instructions

Follow the instructions in this sheet carefully. Failure to follow these instructions could damage your equipment and void its warranty.
 

This article has been archived and is no longer updated by Apple.

Tools Required

The only tool required for this procedure is a Phillips #2 screwdriver.

Note: The memory is located behind the user access door shown below.





Procedure

1. Save open documents and quit all open applications.
2. Turn the computer off by choosing Shut Down from the Special menu.
3. Unplug all cables, except the power cord, from the computer.

Warning: If the internal modem is connected to a telephone line, disconnect the telephone line from the internal modem port before you open the user access door. This prevents electric shock.





4. Place a soft towel or cloth on the desk or surface.
5. Position the computer so the screen is facing down on the cloth.
6. Use a Phillips screwdriver to remove the screw on the user access door shown below.





7. Touch a metal surface inside the computer. Then unplug the power cord. This helps





protect the computer from damage caused by electrostatic discharge.

Important: To avoid electrostatic discharge, always ground yourself by touching metal before you touch any parts or install components inside the computer. To avoid generating static electricity, do not walk around the room until you have finished installing the memory and closed the computer.

8. Locate the open memory slot.





9. Push the ejectors on the memory slot outward and down so they are in the open position. The module is designed to fit into the slot only one way. Be sure to align the notches on the module with the small notches inside the slot.





10. Push down on the memory until it snaps into place. The ejectors will automatically close.
11. Replace the screw on the user access panel.





12. Gently turn the computer right side up.
13. Reconnect the cables you disconnected from the computer.

Important: When connecting the power cord, first plug the cord into your eMac, then plug the other end into an electrical outlet or power strip.

14. Press the Power button on the computer to turn it on.

Warning: Never turn on the computer unless all of its internal and external parts are in place and it is closed. Operating the computer when it is open or missing parts can damage your computer or cause injury.

Last Modified: Jul 9, 2012
Helpful?
Yes
No
Not helpful Somewhat helpful Helpful Very helpful Solved my problem
Print this page
  • Last Modified: Jul 9, 2012
  • Article: HT1319
  • Views:

    236850
  • Rating:
    • 75.0

    (1179 Responses)

Additional Product Support Information

Start a Discussion
in Apple Support Communities
See all questions on this article See all questions I have asked