Apple RAID Card (Early 2009) Firmware Update 1.1 updates RAID card firmware version E-184.108.40.206, E-220.127.116.11 and E-18.104.22.168 to E-22.214.171.124. If your RAID card firmware version begins with M, you have a different version of the Apple RAID Card, and you do not need this update. For more information about identifying which version of the card you are using, see Mac Pro RAID Card: Identification and compatibility or Xserve RAID Card: Identification and compatibility.
This update improves:
- Reliability during startup and power loss recovery.
- Handling hard drives with bad blocks.
- RAID 1 read performance.
- Support for systems with 48GB or more memory.
- Battery handling and reporting.
- Download the update using Software Update or download the installer from Apple Support Downloads. This will install an application called "Apple RAID Card (Early 2009) Firmware Update" in /Applications/Utilities.
- The application will run automatically after you download it (or after your computer restarts, if you have installed other updates at the same time.)
- Follow the instructions in the updater application. You will need your administrator password.
- The firmware update will take several minutes. Important: make sure that power is not interrupted while the firmware updates. When the update completes you will be prompted to restart the computer. After restarting, the updater will run again and report that your RAID card firmware is up to date.
Command line installation instructions
After downloading the updater application you can update the firmware using the command line interface instead of the updater application. Enter these commands, each on a single line:
cd /Applications/Utilities/Apple\ RAID\ Card\ \(Early\ 2009\)\ Firmware\ Update.app/Contents/MacOS
sudo ./raidupdate update --source ../Resources/AppleRAIDCardFirmware.arcupdate
Enter your administrator password when prompted.
The firmware update will take several minutes. Important: Make sure that power is not interrupted while the firmware is being updated. When the update is finished you will be prompted to restart the computer.
If the updater does not report that your firmware is up to date after completing the update and restarting, check the status of your RAID card in Apple System Profiler.
- Open Apple System Profiler by choosing About This Mac from the Apple () menu, then clicking More Info.
- In the Hardware list, select Hardware RAID.
- Select your Mac Pro RAID Card or Xserve RAID Card.
- In the lower status window, look for "Shutdown Status: Normal shutdown". If you see any other status reported, quit the firmware updater and restart your computer.
- After restart, verify that that RAID Card shutdown status is "Normal shutdown", then run the firmware update again.